Battery Filling System 12Volt Kit for HuP Solar One
Only the HuP Solar One 1990 and 2490 Amp Hour battery sets utilize the TB5 Valve Kits. Battery Filling System
K600TB5 for HuP Solar One 12 Volt Kit Safety and labor savings are of the utmost importance in
your battery filling station. These valves are manufactured with the highest
quality materials that keep all working parts above the battery
A basic kit has all of
the components needed to assemble the watering system on a battery. Tubing is
not pre-cut or attached to the barbs on the valves. Each kit includes an
instruction sheet with basic assembly recommendations or the installer can
utilize the desired drawing layout.
Exiting gasses are forced through a drying chamber. This action allows the
escaping gases to leave behind a major portion of electrolyte that may be
attached to the escaping gases. The result is less frequent watering intervals.
Lever Operated Shutoff
When the electrolyte level rises, the lever pulls the shutoff valve in the
closed direction and will not allow the cell to overfill.
The water trap keeps a small amount of water in the valve that will not allow
dangerous hydrogen gas to move from cell to cell.
The patented double chamber designed in each valve keeps dangerous hydrogen gas
and water movements separate.
The valve provides an electrolyte level indicator to determine that each cell
has been properly watered.
A hydrometer port in the valve allows specific gravity checks without removing
Improved Barb Design.
Hoses are almost impossible to remove unintentionally. A better barb angle has
been incorporated to allow ease of installation.
Call Toll Free 888-826-0939 with Questions